PRODUCT SPECS
| Item Code | SGPSA265 | | Item SKU | PSA265 | | Material | Steel | | Brand | Sunglo | | Collection | Permanent Post | | Dimensions | 93H inches | | Weight | 70 lbs | | Btu Input/hour | 50,000 BTUs | | Heating Area | 20 feet | | Reflector Diameter | 34.5 inches | | Fuel Type | Natural Gas | | Wind Rating | 10 mph Horizontal | | Certification | CSA International | | Shiping Boxes | 3 to 4 | | Made In |  |
PRODUCT DESCRIPTION
The Sunglow permanent post heater in an outdoor rated natural gas heater ideal for open patio designs. The in-ground post minimized the deck space required and positions these heaters at the ideal height for comfort and safety. Heat coverage varies depending on the wind exposure on the patio. The average spacing between heaters is 12 feet apart.
The PSA265 heater is available with a variety of control systems. Each control system is equipped with 100% safety shutoff. The standard is a manual heater requiring no electrical hookup. The optional NON "E" with solenoid gas valve allows the heater to be turned OFF/ON at the turn of a switch. The optional "E" Series offers a completely automated ignition system.
Both the NON "E" and "E" Series requires an external 24 VAC source.
This heater offers a large deep disk aluminum reflector for maximum comfort, a primary aerated burner for minimal noise, and 100% safety shutoff. The post is available in a glass black powder-coat finish or 304 stainless steel.
PSA265 heaters require no electrical connection and are the easiest to service and maintain. The heater utilizes a pilot-thermocouple 100% safety shutoff. Pilot must be manually lit. Heater is turned off/on with a manual control knob located at the front of the heater.
NON "E" option require electrical 24 VAC to be connected in order to operate the main burner. This heater utilizes a pilot-thermocouple with 100% safety shutoff. Pilot must be manually lit via the direct spark system. Heater is then turned on/off with an electrical switch, timer or other control device by interrupting the 24 VAC supply to the heater. Control device to be supplied by the installer. Manual control knob must be set to the ON position for this heater to operate with an electrical switch.
The "E" Series option require 24 VAC electrical to be connected in order to operate . This heater utilizes an electronic ignition and monitors the heater through flame rectification. Heater cannot be manually lit. Heater is turned off/on with electrical switch, timer or other control device by interrupting the 24 VAC supply to the heater. Control device to be supplied by the installer.
The required clearance from combustible materials must be maintained on all heaters. In addition heaters must have adequate fresh air and ventilation to operate properly. Make sure you can meet these requirements before making your heater selection.
The primary use of the information above should be used for heater selection only. It should not be used as the sole guide in placement and installation of these heaters. | 
